Gas Lines
Gas Line Repair & Installation in Dallas–Fort Worth
Gas is not a wait-and-see problem. Smell it and you leave. After the utility shuts it down, somebody has to fix the pipe on your side of the meter and prove it holds. That is the part we do.
- Price before work starts
- Your approval before anything begins
- Tested before we leave
Gas Lines: what you're dealing with
Smell gas? Get everybody out of the house first. Touch no light switches. Do not start a car parked in the garage. Do not hunt for the leak. Once you are outside and well clear of the building, phone the gas utility's emergency number or dial 911. Nobody goes back in until the utility says it is safe.
The utility's responsibility ends at the meter. Everything after it is the homeowner's pipe: the buried line across the yard, the piping through the attic or walls, the connector behind each appliance. When a leak is found, the utility turns the gas off at the meter, and it stays off. Getting it back on takes a repair, a pressure test that proves the whole system is tight and, in most cities, an inspection. New lines are part of the same trade: a line to a range or a dryer, a bigger feed for a tankless water heater, a run out to a generator, a pool heater or an outdoor kitchen.
When a gas line needs a look
- The sulfur smell of gas anywhere in the house or yard, even faintly
- Hissing from a pipe joint, a shut-off valve or the flexible line behind an appliance
- A tag on the meter and no gas, because the utility found a leak
- A streak of dead grass between the meter and the house
- Plans for a new range, generator, pool heater or tankless water heater
The job
How the work runs
Gas off first
Nothing is opened, cut or loosened until the supply is shut off and the line is isolated.
Pressure the system
The house piping goes under test pressure with a gauge on it. A falling needle means a leak, and each one gets tracked to its fitting or section.
Price, then pipe
You get the price before the repair starts. Leaking sections are rebuilt or the run is replaced, sized for every appliance it feeds.
Hold the test
The finished line has to hold pressure again. After the city inspection, the utility can restore service.
North Texas
Why it happens here
In many older Dallas-area neighborhoods the gas meter sits at the back of the lot, often on the alley, and a steel line runs underground from there to the house. After fifty-plus years in wet clay, buried steel corrodes. The leak tends to show up as a faint smell in the yard or a failed pressure test. When a yard line has leaked once, replacing the full run with modern polyethylene pipe usually makes more sense than patching rusted steel.
Straight answers
Gas Lines: common questions
What is the first thing to do if I smell gas?
Leave, and take everyone with you. On the way out, keep your hands off light switches, appliances and whatever else might throw a spark. Make the call from outside, at a distance from the building: ring the gas utility on its emergency number, or call 911. The plumbing comes after the utility has shut the gas off.
The utility locked my meter. What happens now?
The lock means a leak was found on your side of the meter. It comes off only after the piping in the house is repaired and holds a pressure test, and most North Texas cities want an inspection as well. With that done, the utility comes back and restores service.
Can my gas line handle a tankless water heater or a generator?
Maybe not. A tankless water heater can burn several times the gas of the tank it replaces, and a standby generator is another large load. The meter and the pipe both have to be sized for everything running at once. The numbers get run on your system before any appliance goes in.
Service area
Gas Lines across DFW
The same work, in every city on the list.
